YOU CAN SEE THE BASIC CONCEPTS OF TECHNOLOGY, HISTORY OF TECHNOLOGY AND MORE INTERESTING INFORMATION ABOUT ELECTRICITY AND POWER GENERATION

Wednesday, May 20, 2009

Barring Gear

Barring gear (or "turning gear") is the mechanism provided to rotate the turbine generator shaft at a very low speed after unit stoppages. Once the unit is "tripped" (i.e., the steam inlet valve is closed), the turbine coasts down towards standstill. When it stops completely, there is a tendency for the turbine shaft to deflect or bend if allowed to remain in one position too long. This is because the heat inside the turbine casing tends to concentrate in the top half of the casing, making the top half portion of the shaft hotter than the bottom half. The shaft therefore could warp or bend by millionths of inches.
This small shaft deflection, only detectable by eccentricity meters, would be enough to cause damaging vibrations to the entire steam turbine generator unit when it is restarted. The shaft is therefore automatically turned at low speed (about one revolution per minute) by the barring gear until it has cooled sufficiently to permit a complete stop.

2 comments: